With ducts or without
Heat Pump Installation in Beverly, MA
Heat in winter, cooling in summer, one system. Sized to your rooms and installed by a crew that explains every control.
Get the Size Right and Everything Else Follows
Here is the most common heat pump mistake we see. Someone pulls out a gas furnace and drops in a heat pump with the same rating. Sounds logical. It is not. Heat pumps run best when they match the home's real heat loss, and older homes lose heat in very uneven ways. A drafty front bedroom. A kitchen that stays warm on its own. A finished attic that swings all over the place. So we measure. Every room, every exposure, the windows, the insulation we can see. That turns into a design, and the design picks the equipment. If you have usable ductwork, a ducted system can run through it. If you have radiators or baseboard, ductless heads go where they will actually reach the room. Either way it is cold-climate equipment, built to keep producing heat through the worst cold of the year. HVAC Financing Beverly is a licensed contractor in Massachusetts, and the install is done start to finish by our crew. Line sets run neat. Floors get covered. The old system is handled the way you chose and the way the rebate requires. Then we start it up, test it and walk you through each thermostat or remote. If you are going for the Mass Save rebate, worth up to $8,500 in 2026 for qualifying whole-home installs with eligibility rules attached, the equipment is matched to the program before we order it.
What You Get With an Install
No two houses match, but these show up on nearly every job.
Heat-loss measurements
Room sizes, windows and insulation recorded so the system is sized to the house.
Cold-climate equipment
Units listed to keep producing heat through a hard New England cold snap.
Ducted or ductless design
Existing ducts reused when they are in good shape. Heads placed where ducts do not exist.
Outdoor unit setup
Mounted on a pad or bracket, up out of the snow, with room to breathe.
Clean line-set runs
Refrigerant lines routed neatly and covered so the house still looks like your house.
Thermostats and controls
Zone controls set up. A boiler kept as backup gets integrated controls too.
Startup and testing
Charge, airflow and drainage checked before we call it done.
Your walkthrough
We show you every setting and how to clean the filters.
Three Stops From Call to Comfort
Visit and measure
We walk the house, size the rooms, look at the current heat and agree on where the equipment goes.
Proposal on paper
You get the equipment, price and rebate estimate in writing. Read it at your own pace. Nothing gets ordered until you say yes.
Install and hand-off
The crew sets the units, runs the lines, wires the controls and tests everything. You get a full walkthrough before we leave.
Why Homeowners Pick Us to Install
Licensed in Massachusetts
A licensed contractor does the work and handles the permits.
Sizing you can see
We show you how each room was sized before talking model numbers.
No mess left behind
Covered floors, tidy lines and a clean work area at the end of each day.
- Licensed contractor
- Room-by-room sizing
- Cold-climate units
- Full walkthrough
Want to Know What Your House Needs?
Tell us how you heat now and which rooms bug you. We will explain what a heat pump setup could look like.